SWIM N SPA SANITIZER & SHOCK: CHLOR 62 (50 LB)
SWIM N SPA SANITIZER & SHOCK: CHLOR 62 (50 LB)
Swim N Spa Chlor 62 is designed to dissolve quickly and completely providing a steady source of available chlorine to control the growth of algae, kill bacteria and destroy organic contaminants.
ACTIVE INGREDIENT:
Sodium Dichloro-s-Triazinetrione
Dihydrate.........................................................................99%
OTHER INGREDIENTS................................................1%
Total..............................................................................100%
Available Chlorine.................................55.5%
DIRECTIONS FOR USE:
METHOD OF APPLICATION:
Broadcast the product evenly over a wide area in the deepest part of the pool or spa with
water circulating.
POOL ROUTINE CHLORINATION:
Throughout the pool season, adjust pH to 7.2-7.6 with appropriate pool care products. Follow
label directions. Broadcast 3 oz. of this product per 10,000 gallons pool water every other day or as often as needed to
maintain chlorine residual at 2-4 ppm. This quantity may vary depending on bather load, temperature and other conditions.
Re-entry into treated pools is prohibited above levels of 3 ppm chlorine. As a preventative treatment, you should shock treat
weekly to prevent pool problems which may occur when bathing loads are high, water appears hazy or dull, unpleasant
odors or eye irritation occur, after heavy wind and rain storms, when temperatures are high, in case of colored water, or if
algae develops with resulting green color and slimy feeling.
SPA AND HOT TUB USE:
Each level teaspoon (0.17 oz.) of this product will provide approximately 1.4 ppm available
chlorine in 500 gallons of water. Using an appropriate test kit, test and adjust the water to the following values: pH 7.2-7.8,
total alkalinity 60-100 ppm, calcium hardness 200 ppm minimum. Maintain these conditions for proper spa and hot tub
operation by frequent testing with a test kit. Do not allow cyanuric acid level to exceed 150 ppm. It is recommended that
spas and hot tubs be drained every 30-90 days. More often under heavy use. Consult manufacturer’s recommendations
concerning the compatibility of chlorine sanitizers with their equipment. Some oils, lotions, fragrances and cleaners may
cause foaming or cloudy water and may react with chlorine sanitizers to reduce their efficacy.
START-UP (FRESHLY FILLED)
1. Turn on the circulation system and ensure that it is operating properly.
2. Add 6 teaspoons of this product for each 500 gallons of water.
Check the free available chlorine (FAC) and, if below 4-5 ppm, repeat as needed. Re-entry into treated spas is prohibited
above levels of 3 ppm of chlorine.
REGULAR USE:
Turn on the circulation system and ensure that it is operating properly. Scatter approximately 3 teaspoons per 500 gallons
of this product over the surface of water. Always use a clean, dry spoon. Test for FAC and add additional product, if
necessary, to attain 4-5 ppm FAC. Maintain 1-3 ppm FAC while the spa or hot tub is in use. After each use, shock treat with
9 teaspoons per 500 gallons water to control odors and algae. Repeat as needed. Re-entry into treated spas is prohibited
above levels of 3 ppm of chlorine.
NOTE: CHLOR 62 CAN ONLY BE SHIPPED TO ILLINOIS, IOWA & WISCONSIN!